Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front bumper Service and Repair.

3. Left side: Detach the clip (A), then remove the bolts (B), then release the intake air resonator (C).






4. Disconnect the left or right engine compartment wire harness 2P connector (A) from the front impact sensor (B).





5. Remove the TORX bolts (C) using a TORX T30 bit, then remove the front impact sensor.

Installation

1. Install the front impact sensor (A) with the new TORX bolt (B) using a TORX T30 bit, and tighten the TORX bolt to the specified torque.





2. Connect the left or right engine compartment wire harness 2P connector (C) to the front impact sensor.

3. Do the battery terminal reconnection procedure.

4. Clear any DTCs with the HDS.

5. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

6. Left side: Install the intake air resonator (A) with the bolts (B), and tighten the bolts to the specified torque, then push the clip (C).






7. Install the front bumper Service and Repair.