A/T Differential Carrier Bearing Replacement

A/T Differential Carrier Bearing Replacement

Special Tools Required

- Installer Attachment, 45 x 55 mm 07MAD-PR90100

NOTE:

- The carrier bearing and the carrier bearing outer race should be replaced as a set.
- Inspect and adjust the carrier bearing preload whenever the bearing is replaced.
- Check the bearing for wear and rough rotation. If the bearing is OK, removal is not necessary.

1. Remove the carrier bearing (A) using a commercially available bearing puller (B), a bearing separator (C), and a spacer (D).






2. Install a new carrier bearing until it bottoms using the 45 x 55 mm installer attachment and a press.