B1036

DTC Troubleshooting: B1036

DTC B1036:

Driver's MICU IG1 Line Input Error

NOTE:

- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.
- Before troubleshooting, make sure the No. 5 (7.5 A) fuse in the driver's under-dash fuse/relay box is OK.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1036 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections at the driver's under-dash fuse/relay box connector C (5P). If the connections are good, check the battery condition Battery Test and the charging system.

5. Measure the voltage between gauge control module 32P connector terminals No. 15 and body ground.





Is there battery voltage?

YES -

Faulty driver's MICU; replace the driver's under-dash fuse/relay box, USA models Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (USA Models), Canada models Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (Canada Models).

NO -

Repair an open in the wire between the driver's under-dash fuse/relay box and the gauge control module.