A/T
DTC Troubleshooting: P0011, P0011
DTC P0011:
VTC System Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information How to Troubleshoot the Fuel and Emissions Systems.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. Watch the low oil pressure indicator with the engine running.
Is the low oil pressure indicator on?
YES -
Check the engine oil level. If the level is OK, check the engine oil pressure Testing and Inspection, then go to step 15.
NO -
Go to step 5.
5. Do the VTC TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES -
Go to step 6.
NO -
Go to step 9.
6. Test-drive at a steady speed between 19-38 mph (30-60 km/h) for 10 minutes.
7. Check the VTC STATUS in the DATA LIST with the HDS.
Does it indicate ON?
YES -
Go to step 8.
NO -
Go to step 6 and recheck.
8. Monitor the OBD STATUS for DTC P0011 in the DTCs MENU with the HDS.
Does the HDS indicate FAILED?
YES -
Go to step 9.
NO -
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, go to step 5 and recheck.
9. Turn the ignition switch to LOCK (0).
10. Remove the auto-tensioner Service and Repair.
11. Remove the VTC strainer (A), and check it for clogging.
Is the strainer OK?
YES -
Go to step 12.
NO -
Clean the VTC strainer, replace the engine oil filter Service and Repair and the engine oil Service and Repair, then go to step 14.
12. Test the VTC oil control solenoid valve Testing and Inspection.
Is the VTC oil control solenoid valve OK?
YES -
Go to step 13.
NO -
Replace the VTC oil control solenoid valve Testing and Inspection, then go to step 14.
13. Inspect the VTC actuator Testing and Inspection.
Is the VTC actuator OK?
YES -
Check the VTC system oil passages and clean them if needed, then go to step 14.
NO -
Replace the VTC actuator Service and Repair, then go to step 14.
14. Turn the ignition switch to ON (II).
15. Reset the ECM/PCM with the HDS.
16. Do the ECM/PCM idle learn procedure ECM/PCM Idle Learn Procedure (M/T).
17. Do the CKP pattern clear/CKP pattern learn procedure.
18. Do the VTC TEST in the INSPECTION MENU with the HDS.
19. Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0011 indicated?
YES -
Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to step 1.
NO -
Go to step 20.
20. Monitor the OBD STATUS for DTC P0011 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -
Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 19, go to the indicated DTC's troubleshooting.
NO -
If the HDS indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to step 1. If the HDS indicates NOT COMPLETED, go to step 18.