A/T System

DTC Troubleshooting: U0122 (107)

DTC U0122:

F-CAN Malfunction (PCM-VSA Modulator-Control Unit)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review the General Troubleshooting Information How to Troubleshoot the A/T System.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Check for Pending or Confirmed DTCs in the PGM-FI System with the HDS.

Is DTC U0122 indicated in the PGM-FI SYSTEM?

YES -

Go to the DTC U0122 troubleshooting in the PGM-FI SYSTEM A/T.

NO -

Go to step 4.

4. Check for Pending or Confirmed DTCs in the A/T SYSTEM with the HDS.

Is DTC U0122 indicated in the A/T SYSTEM?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. If any other Pending or Confirmed DTCs were indicated, go to the indicated DTC's troubleshooting.

5. Update the PCM if it does not have the latest software ECM/PCM Update (M/T), or substitute a known-good PCM.

6. Start the engine, and wait for at least 2 minutes.

7. Check for Pending or Confirmed DTCs in the A/T SYSTEM with the HDS.

Is DTC U0122 indicated in the A/T SYSTEM?

YES -

Check for poor connections or loose terminals between the VSA modulator-control unit and the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 6. If the PCM was substituted, go to step 1.

NO -

Go to step 8.

8. Monitor the OBD STATUS for U0122 in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES -

If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM Service and Repair. If any other Pending or Confirmed DTCs were indicated in step 7, go to the indicated DTC's troubleshooting.

NO -

If the HDS indicates FAILED, check for poor connections or loose terminals between the VSA modulator-control unit and the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 6. If the PCM was substituted, go to step 1. If the HDS indicates NOT COMPLETED, go to step 6.