Driver's Power Seat Motor Test (Without DPMS)

Driver's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the driver's seat Front Seat Removal / Installation.

2. Disconnect the connector from each power seat motor.

NOTE: All connectors are terminal side of male terminals.










3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace the motor:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor/seat frame
- Rear up-down motor/seat frame
- Recline motor Front Seat Recline Motor Replacement