Excessive Shock or Flares on 4-5 Upshift or 5-4 Downshift

Excessive shock or flares on 4-5 upshift or 5-4 downshift

A/T clutch pressure control solenoid valve B defective

A/T clutch pressure control solenoid valve C defective

Foreign material in separator plate orifice

4th accumulator defective

5th accumulator defective

4th clutch defective

5th clutch defective

Notes

Inspect the A/T clutch pressure control solenoid valve filter/gasket and the O-rings for wear and damage, and inspect the solenoid valves for seizure.

Notes

Check the 4th and 5th clutch pressures A/T Pressure Test.

Notes

Check for a clogged orifice in the separator plate. If the orifice is clogged, remove it and clean the separator plate orifice.

Notes

Inspect the clutch piston, the clutch piston check valve, and the O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the clutch end-plate and the top disc. If the clearance is out of tolerance, inspect the clutch discs and the plates for wear and damage. If the discs are worn or damaged, replace them as a set. Inspect the clutch wave-plate height. If the height is out of tolerance, replace the wave-plate. If the discs and the plates are OK, adjust the clearance with the clutch end-plate.

Notes

Inspect the 5th clutch feed pipe. If the 5th clutch feed pipe is scored, replace it and the O-ring under the feed pipe guide.

Notes

Replace the mainshaft if the bushing for the 5th clutch feed pipe is loose or damaged.

Notes

Check the 4th and 5th accumulator pistons, the O-rings, and the springs in the servo body for wear and damage.