A/T Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)

A/T Secondary Shaft Disassembly, Inspection, and Reassembly

1. Inspect the thrust needle bearings and the needle bearings for galling and rough movement.





2. Inspect the splines for excessive wear and damage.

3. Check the shaft bearing surface for scoring and excessive wear.

4. Before installing new O-rings, wrap the shaft splines with tape to prevent the O-ring damage.

5. Lubricate all parts with ATF during assembly.

6. Install the conical spring washer and the idler gear in the direction shown.

7. Replace the locknut and the conical spring washer with new ones when assembling the transmission. The locknut has left-hand threads.

8. Check the clearance of 2nd gear A/T Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T) and 1st gear A/T Secondary Shaft 1st Gear Axial Clearance Inspection (A/T).