M/T Countershaft Bearing Replacement

M/T Countershaft Bearing Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Oil Seal Driver, 65 mm 07JAD-PL90100
- Slide Hammer 3/8''-16 UNF, commercially available

1. Remove the bearing set plate (A) from the clutch housing (B).






2. Remove the needle bearing (A) using the 25-40 mm adjustable bearing puller (B) and a commercially available 3/8''-16 UNF slide hammer (D), then remove oil guide plate C.






3. Position oil guide plate C and a new needle bearing (A) in the bore of the clutch housing (B).





4. Install the needle bearing using the 65 mm oil seal driver (D).

5. Install the bearing set plate (A) with the flange bolts (B).