Torque Converter Housing Countershaft Bearing Replacement

Torque Converter Housing Countershaft Bearing Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100

1. Remove the countershaft bearing from the torque converter housing using the 25-40 mm adjustable bearing puller and a commercially available 3/8 ''-16 slide hammer (A).






2. Install the ATF guide plate (A) into the torque converter housing, then install the bearing (B) in the direction shown.






3. Install the bearing (A) in the torque converter housing using the driver handle and the 78 x 80 mm bearing driver attachment; install the bearing outer notch-cut (B) to a depth (C) of 0-0.03 mm(0-0.001 in) below the torque converter housing surface (D).