Operation CHARM: Car repair manuals for everyone.

A/T Countershaft Reverse Selector Hub and 3rd Gear Removal (A/T)




A/T Countershaft Reverse Selector Hub and 3rd Gear Removal

1. Install a commercially available bearing separator on 4th gear (A). Set the countershaft (B) on a press with a spacer (C) between the press and the countershaft, and remove the reverse selector hub (D).

NOTE: Some reverse selector hubs are not press-fitted, and can be removed without using the bearing separator and a press.





2. Remove the needle bearing, the set ring, the 35 x 47 x 7.8 mm collar, and the 31 mm cotters.

3. Set the countershaft (A) on the press with the spacer (B) between the press and the countershaft, and remove 3rd gear (C).





4. Remove the 37 x 41 x 54.3 mm collar, 5th gear, 1st gear, and 2nd gear.