B1129

DTC Troubleshooting: B1129

DTC B1129:

Driver's Door Lock Knob Switch Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Operate the driver's door lock knob switch several times.

4. Check for DTCs with the HDS.

Is DTC B1129 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the driver's door lock knob switch system is OK at this time. Check for loose or poor connections.

5. Select KEYLESS TRANSMITTER from the BODY ELECTRICAL SYSTEM SELECT menu, and enter the DATA LIST.

6. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (LOCK) and the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK).

Is the DRIVER'S DOOR LOCK KNOB SWITCH (LOCK) information indicator ON and the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) information indicator OFF with the driver's door lock knob switch in LOCK position, and is the DRIVER'S DOOR LOCK KNOB SWITCH (LOCK) information indicator OFF and the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) information indicator ON with the driver's door lock knob switch in UNLOCK position?

YES -

Replace the power window master switch Power Window Master Switch Replacement.

NO -

Go to step 7.

7. Disconnect the driver's door lock actuator 10P connector.

8. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (LOCK) and DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

Are both information indicators OFF?

YES -

Go to step 12.

NO -

Go to step 9.

9. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

10. Disconnect the power window master switch 37P connector.

11. Check for continuity between body ground and power window master switch 37P connector terminals No. 30 and No. 31 individually.





Is there continuity?

YES -

Repair a short to ground in the LOCK or UNLOCK wire(s).

NO -

Replace the power window master switch Power Window Master Switch Replacement.

12. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

13. Disconnect the power window master switch 37P connector.

14. Check for continuity between power window master switch 37P connector terminals No. 30 and No. 31.





Is there continuity?

YES -

Repair a short between the LOCK and UNLOCK wires.

NO -

Check for an open or high resistance in the driver's door lock knob switch (LOCK) wire or the driver's door lock knob switch (UNLOCK) wire between the door multiplex control unit and the driver's door lock knob switch. If the wire is OK, the driver's door lock knob switch is faulty; replace the driver's door latch Service and Repair.