113-1

VSA DTC Troubleshooting: 113-1

DTC 113:

Yaw Rate-Acceleration Sensor Power Source Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Reading and Clearing Diagnostic Trouble Codes.

1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

2. Disconnect the yaw rate-acceleration sensor 4P connector Service and Repair.

3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

4. Measure the voltage between body ground and yaw rate-acceleration sensor 4P connector terminal No. 1.





Is there battery voltage?

YES -

Replace the yaw rate-acceleration sensor Service and Repair.

NO -

Repair an open in the wire between the No. 6 (7.5 A) fuse in the driver's under-dash fuse/relay box and the yaw rate-acceleration sensor.