Manufacturer Code Charts: 1301

Navigation System DTC Troubleshooting: 1301

DTC 1301:

GPS Antenna Error

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How To Troubleshoot The Navigation System.
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and wait at least 1 minute.

4. Check for the hard error code.

Is DTC 1301 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Check for poor connections or loose terminals at audio-navigation unit connector J (2P).

Are there connections or terminals OK?

YES -

Replace the GPS Antenna Service and Repair.

NO -

Repair poor connections or loose terminals, and recheck. If the code continues to reset intermittently, replace the GPS antenna Service and Repair.