DTC Troubleshooting

DTC Troubleshooting: P0116

DTC P0116:

ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

2. Check ECT SENSOR 1 in the DATA LIST with the HDS.

Is about 176 °F (80 °C) or more, or 0.78 V or less indicated?

YES -

Go to step 6.

NO -

Go to step 3.

3. Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.

4. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

5. Check ECT SENSOR 1 in the DATA LIST with the HDS.

Does ECT SENSOR 1 change 18 °F (10 °C) or more?

YES -

Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM.

NO -

Go to step 11.

6. Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.

7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

8. Open the hood, and let the engine cool for 3 hours.

9. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

10. Check ECT SENSOR 1 in the DATA LIST with the HDS.

Does ECT SENSOR 1 change 18 °F (10 °C) or more?

YES -

Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM.

NO -

Go to step 11.

11. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

12. Replace ECT sensor 1 ECT Sensor 1 Replacement.

13. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

14. Reset the PCM with the HDS.

15. Do the PCM idle learn procedure PCM Idle Learn Procedure.

16. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0116 indicated?

YES -

Check for poor connections or loose terminals at ECT sensor 1 and the PCM, then go to step 1.

NO -

Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.