Advanced Diagnostics
Advanced Diagnostics - DTC P1174: Front Air/Fuel Ratio (A/F) Sensor (Bank 2, Sensor 1) Circuit Out Of Range HighGeneral Description
If a malfunction causes the front air/fuel ratio (A/F) sensor (bank 2, sensor 1) signal to the powertrain control module (PCM) to deviate from the normal control area, the front A/F sensor may still become active after the engine starts, but the air/fuel feedback does not start normally and the emissions deteriorate. When the front A/F sensor output is out of the normal area, and this condition continues after the front A/F sensor is active, the PCM detects a malfunction and stores a DTC.
Monitor Execution, Sequence, Duration, DTC Type, OBD Status
Enable Conditions
Malfunction Threshold
A malfunction is detected when the front A/F sensor (bank 2, sensor 1) output voltage is 4.7 V or more.
Driving Pattern
1. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on.
2. Air/fuel ratio feedback is started while idling, hold for at least 7 seconds.
Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC and the freeze data are stored.
Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the battery.