Gauge Control Module

DTC Troubleshooting: U1282

DTC U1282:

Gauge Control Module Lost Communication With Driver's MICU

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC U1282 indicated?

YES -

Replace the gauge control module Service and Repair.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections between the gauge control module and the driver's MICU.