Instrument Fascia Removal / Installation

Instrument Fascia Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove these items:

- Driver's outer dashboard trim Driver's Outer Dashboard Trim Removal / Installation
- Driver's inner dashboard trim Driver's Inner Dashboard Trim Removal / Installation

2. Adjust the steering column to the full tilt down position, and to the full telescopic out position.

3. Detach the clips and release the hooks (A) fastening the instrument fascia (B) from the upper column cover (C).

NOTE: Make sure you do not damage the fabric.






4. Gently pull out the bottom to detach the clips, and disconnect the dashlights brightness controller switch connector (A), then remove the instrument fascia (B).





5. Install the instrument fascia in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips and the hooks into place securely.