Interior Trim Removal / Installation - Cargo Area

Interior Trim Removal/Installation - Cargo Area

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

Floor Lid

NOTE:

- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim or the panel.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove the front floor lid (A).






2. Open the rear floor lid (A). Pry out the clips (B) on both ends of the rear floor lid support struts (C), and then remove the support struts from the pivot bolts (D). Do not remove the clips from the struts.

NOTE: Use eye protection when doing this procedure.






3. Close the rear floor lid (A). Remove the screws, then remove the rear floor lid.






4. If necessary, remove the tool box spacer (A).






5. Install the floor lid in the reverse order of removal.

Rear Trim Panel

NOTE:

- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim or the panel.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the tailgate weatherstrip near the rear trim panel as needed Service and Repair.

2. Remove the rear trim panel (A).

1. Open the rear floor lid.

2. Pry out the covers (B), and remove the screws (C), then remove the tie down hooks (D).

3. Release the hooks (E) and the tabs (F) from the rear side trim panels.

4. Pull up the rear trim panel by hand to detach the clips.





3. Install the trim and panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips, the hooks, and the tabs into place securely.

Seat Flap Assembly

1. Remove the front floor lid and the tool box spacer.

2. Remove the screw, then pull up the seat flap assembly (A) by hand to detach the clips, and remove it.






3. Install the seat flap assembly in the reverse order of removal and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.

Floor Lid Handle

1. Remove the floor lid.

2. Remove the screws, then remove the handle case (A) and the handle (B) from the floor lid.






3. Install the floor lid handle in the reverse order of removal.

Rear Under Floor Cover

1. Remove the rear side trim panel Interior Trim Removal / Installation - Rear Side Area.

2. Detach the clips, then remove the rear under floor cover (A).






3. Install the rear under floor cover in the reverse order of removal and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.