Interior Trim Removal / Installation - Rear Side Area

Interior Trim Removal/Installation - Rear Side Area

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

Rear Side Trim Panel

NOTE:

- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim or the panel.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the cargo area side lid (A).






2. Remove these items:

- Rear seat side bolster
- Front floor lid
- Rear floor lid
- Tailgate weatherstrip, as needed Service and Repair
- Rear trim panel

3. Fold down the seat-back.

4. Remove the rear side trim panel (A).

1. Pry out the cover (B) and remove the screw (C), then remove the tie down hook (D).

2. Detach the clips (E) from the front area of the trim panel.

3. Pull back the upper edge of the trim panel to release the hooks (F) from the quarter pillar trim (G).

4. Pull out the trim panel back by hand to detach the clips (H).

5. Pull the front area of the trim panel inward to release it from the rear seat-back striker (I).

6. Disconnect the cargo area light connector (J).





5. Install the trim panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips, the hooks, and the tabs into place securely.