Power Mirror Actuator Test

Power Mirror Actuator Test

1. Remove the door mirror cover Power Mirror Replacement.

2. Disconnect the 16P connector (A) from the door mirror actuator (B).






3. Check the actuator operation by connecting power and ground according to the table.

LEFT





RIGHT





4. If the mirror fails to work properly, check for an open or high resistance in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror actuator Service and Repair.

Defogger Test

5. Check for continuity between power mirror 16P connector terminals No. 1 and No. 2. There should be continuity.

6. If there is no continuity, check for an open or high resistance in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror holder Mirror Holder Replacement.