Headlamp Alignment Sensor: Service and Repair

Suspension Stroke Sensor Replacement

Front

1. Press the engine start/stop button to select the OFF mode.

2. Raise and support the vehicle Service and Repair.

3. Remove the front wheel.

4. Disconnect the suspension stroke sensor 3P connector (A).





5. Remove the nuts, then remove the suspension stroke sensor (B).

NOTE: Use the new 6 mm nut during reassembly.

6. Install the suspension stroke sensor in the reverse order of removal.

Rear

1. Press the engine start/stop button to select the OFF mode.

2. Raise and support the vehicle Service and Repair.

3. Remove the rear wheel.

4. Disconnect the suspension stroke sensor 3P connector (A).





5. Remove the bolts and the nut, then remove the suspension stroke sensor (B).

NOTE: Use the new 6 mm nut during reassembly.

6. Install the suspension stroke sensor in the reverse order of removal.

7. Do the memorizing rear suspension full rebound position Programming and Relearning.