TPMS Indicator Does Not Come On, and No DTCs Are Stored

TPMS Symptom Troubleshooting - TPMS indicator does not come on, and no DTCs are stored

TPMS indicator does not come on, and no DTCs are stored

1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

2. Disconnect the TPMS control unit 20P connector Service and Repair.

3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

4. Check the TPMS indicator when the ignition switch is turned ON (II), or the engine start/stop button is pressed to select the ON mode.

Did the indicator come on?

YES -

Check for loose terminals and poor connections at the TPMS control unit. If necessary, substitute a known-good TPMS control unit Service and Repair, and recheck.

NO -

Do the troubleshooting for the gauge control module Testing and Inspection. If necessary, substitute a known-good gauge control module Service and Repair, and recheck.