Programming and Relearning

Memorizing Rear Suspension Full Rebound Position

Do the rear suspension full rebound position memorizing whenever you do any of these actions:

- Replace the active damper control unit.
- Replace the rear damper unit.
- Replace the rear suspension stroke sensor.
- In the specific DTC troubleshooting.

1. Press the engine start/stop button to select the OFF mode, connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.





2. Press the engine start/stop button to select the ON mode.

3. Make sure the HDS communicates with the vehicle and the active damper control unit. If it does not, troubleshoot the DLC circuit Testing and Inspection.

4. Check for DTCs and make sure no DTC is indicated.

NOTE: For specific operations, refer to the Help menu that came with the HDS.

5. Press the engine start/stop button to select the OFF mode.

6. Raise and support the vehicle Service and Repair.

NOTE: Verify the rear tires are suspended off the ground.

7. Make sure the rear suspension stroke sensors are installed correctly, and the linkages are properly connected.

8. Press the engine start/stop button to select the ON mode.

9. Follow the screen prompts on the HDS to do the DAMPER STROKE CALIBRATION.

NOTE: For specific operations, refer to the Help menu that came with the HDS.

10. Press the engine start/stop button to select the OFF mode.