Transfer Output Shaft Transmission Housing Bearing Replacement

Transfer Output Shaft Transmission Housing Bearing Replacement

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver, 66 mm 07947-3710200

1. Remove the transfer output shaft bearing (A) from the transmission housing (B) by heating the transmission housing to about 212 °F (100 °C) with a heat gun (C). Do not heat the transmission housing more than 212 °F (100 °C).






2. Install a new bearing in the transmission housing in the direction shown.






3. Drive a new bearing until it bottoms in the transmission housing using the 15 x 135L driver handle and the 66 mm oil seal driver.