Battery: Service and Repair

12 Volt Battery Terminal Disconnection and Reconnection

Disconnection
1. Make sure the vehicle ignition is in the OFF mode.
2. Disconnect and isolate the negative cable with the battery sensor (A) from the 12 bolt battery.

NOTE:
- Always disconnect the negative side first.
- To protect the battery sensor connector (B) from damage, do not hold it when removing the negative terminal.
- Do not disconnect the battery sensor from the negative terminal (C).







3. Disconnect the positive cable (D) from the 12 bolt battery.

Reconnection

NOTE: If the 12 bolt battery performs abnormally, test the 12 bolt battery.

1. Clean the battery terminals.
2. Connect the positive cable (A) to the 12 bolt battery.

NOTE: Always connect the positive side first.







3. Connect the negative cable and the battery sensor (B) to the 12 bolt battery.

NOTE: To protect the battery sensor connector (C) from damage, do not hold it when installing the negative terminal.

4. Apply multipurpose grease to the terminals to prevent corrosion.