Rear Seat Combination Belt - Removing/Installing
86audi2Applies To
5000
WAGON
ALL
Group
68
Subject
Rear Seat Belt
Part Identifier 6876
Key Points
Removing/installing rear seat combination belt
A238
Number
86-01
May 12, 1986
Seat belts with inertia reel locking mechanisms are built into rear seat backrest cushions of all 5000 wagons.
Removing/installing
Work sequence
- remove bottom seat cushion
- unbolt seat belt from floor
- remove headrest
- unclip and remove headrest guide
- detach and remove backrest lock mechanism
- insert flat edged screwdriver between each clip and seat backrest
- pry apart (arrow) moving on to each clip around entire seat backrest
Note
Take care not to damage seat upholstery material.
- unclip upper trim piece (arrow)
- pull backrest cover back, remove belt
- detach retractor mechanism (arrows)
^ note position of spacer (top arrow), limiter button
Installation Work sequence
- install all components in reverse order
Note
^ check proper position of limiter button. Install only with belt in unextended position
^ torque backrest lock mechanism bolts to 8 +/- 1 N-m (5.9 +/- .737 ft.lbs.)
^ check belt system for proper function