Throttle Valve Switches - Checking and Adjusting
83audi01Applies To AUDI 5000
AUDI 4000 (5 Cyl)
QUATTRO
1984
Group
25
Subject:
Protractor # 3084
Part Identifier
Key Points
Throttle valve switches: Checking and adjusting
A 040
Number
83-01
August 22, 1983
Throttle valve switches: Idle and full throttle checking/adjusting Idle switch Work sequence
- loosen upper left bolt from throttle valve housing
- attach pointer and tighten bolt
- attach protractor to 1st stage throttle valve shaft (remove nut if necessary)
- disconnect switch wire plug and connect ohmmeter
- adjust protractor to "zero"
- open throttle approx. 20~ and close slowly
^ specification: "zero" ohms at 1 to 2.5~
If not within specifications, remove throttle valve housing and adjust idle switch (arrows).
Note
Ohmmeter must indicate continuity (0 ohms) before throttle reaches idle position.
Full throttle switch
^ leave pointer attached to throttle valve housing
- attach protractor to 2nd stage throttle valve shaft (remove nut if necessary)
- remove full throttle switch connectors and connect ohmmeter
- open 2nd stage throttle fully and "zero" protractor
- close throttle valve approx. 30~
- open throftle valve slowly and watch protractor
^ specifications: "zero" ohms at 12~ to 8~ before full throttle
- if not, adjust full throttle switch
Note
Ohmmeter must indicate zero ohms at full throttle.