A/C Load Compressor Clutch On/Off, (CIS-E III)

- disconnect 35 PIN harness connector from the injection control unit
- connect multimeter US 1119 between terminals 33 and 35 (ground)
- with A/C in OFF position, switch ignition ON
^ specification: 0 volts

If specification is NOT obtained:
- repair break in wiring using wiring diagram
- with A/C in AUTO or BI-LEVEL position switch ignition ON
^ A/C compressor clutch must become energized
^ specification: approximately 12 volts

If specification is NOT obtained
- repair break in wiring using wiring diagram