Girling

Brake pads, replacing

Remove wheels

CAUTION: When re-using brake pads, mark to prevent changing inside to outside or from one caliper to another.






Remove lower caliper mounting bolt (hold guide pin with open end wrench while loosening)






Swing brake caliper up and remove brake pads






Push piston into caliper housing

CAUTION: Always remove some brake fluid from the reservoir before installing new brake pads. When the caliper piston is pushed back, fluid is forced Out of the caliper and into the reservoir. After pads are installed, refill the reservoir only to the MAX mark.

Install brake pads and heat shield
Swing brake caliper down and tighten new caliper securing bolts to 35 Nm (25 ft lb)

Note: Depress brake pedal firmly several times while vehicle is stationary to permit piston and brake pads to adjust to brake disc.