Rear Brake, Basic Adjustment

Rear brake basic setting, checking

Note: Parking brake cable must be free of tension during basic setting check.

Work sequence






Use a screwdriver to push caliper lever against stop on both sides of vehicle






Parking brake cable is too tight if lever of opposite side caliper is pulled away from stop (arrow)






Loosen adjustment nut for parking brake cable (arrow) until both levers rest against stop






Push a screwdriver of at least 6mm dia. between rear hook of spring and roller
Pump brake pedal with moderate force about 40 times (engine not running)
Check that both wheels rotate freely
Remove screwdriver