Driver's Side Headlight High Beam Alignment, Checking

- Switch headlights ON in high beam position.

- Realign Beamsetter box with the high beam headlight if necessary.





- Set Beamsetter "Scaled wheel" to 0%.

- Cover low beam lamp (use hand or small piece of cardboard) and check that the "hot spot" of high beam pattern is centered on the square target box of the pattern screen.

Note:
High beam pattern is built into the reflector design and cannot be adjusted separately

If high beam pattern is way out of adjustment:

- Inspect for reflector damage.

- Replace reflector if needed.

Note:
Always align headlight in the low beam position.

Fog lamp, alignment

- Switch fog lamps ON.

- Align Beamsetter box with fog lamp (make sure it is between 30 and 70 cm from the fog lamp lens).





- Set Beamsetter scaled wheel to 1.4%.

Adjust fog lamp so the top of the beam pattern aligns with the centerline of the target grid on the beam pattern screen.