Wheel Bearing Housing, Servicing
Rear wheel bearing housing, removing/installingCAUTION: Remove and install axle bolt only with wheels on the ground. Do not move vehicle without driveshaft outer cv joint installed or wheel bearing will be damaged.
Removing
- remove wheel trim
- loosen wheel lug bolts
- remove axle bolt
- remove wheel bolts and wheel
- remove bolt holding caliper (arrow)
- remove caliper and secure to body with wire
- remove brake disc
- remove nut and bolt (arrow) securing transverse link to wheel bearing housing
- remove bolt from lower suspension strut mounting
- remove bolt securing wheel bearing housing to trapezoidal arm (lower arrow)
- remove wheel speed sensor
- remove bolt from pivot mount to wheel bearing housing (arrow)
- remove wheel bearing housing from axle shaft
Installing
- Proceed in reverse order of removal and note the following:
- press speed sensor in to stop by hand