Coupe

1 - Hex head bolt
23 Nm (17 ft lb)
2 - Washer
3 - Impact absorber
removing:
• disassemble bumper
• unscrew hex heed bolts
4 - Washer
three washer per impact absorber
5 - Hex head bolts
three bolts per impact absorber
6 - Washer
7 - Pan hard screw
23 Nm (17 ft lb)
8 - Spoiler
removing:
• disassemble bumper
• remove expanding clips, Fig 1
• unbolt spoiler from wheel well housing, Fig. 2
• unbolt upper mounting bolts on spoiler, Fig. 3
• disconnect headlight washers or fog lights if applicable
• remove spoiler by pulling straight Out from body
9 - Fog lamp
if applicable, does not need to be removed when removing spoiler
10 - Bumper beam
to remove, bumper cover and trim must be removed first
11 - Trim strip
12 - Bumper cover
can be removed after bumper is disassembled
13 - Screw/washer
6 Nm (53 in lb)
14 - Bracket
spoiler must hook into bracket when installing
15 - Screw/washer
6 Nm (53 in lb)
16 - Washer
17 -Screw
1.0 Nm (8.9 in lb)
18 - Self tapping pan head screw
19 - License plate bracket
20 - Nut
21 - Headlight washer jet
removing:
• remove bumper
• unscrew hex nut from inside
• remove washer jet from front
22 - Hex nut
secures headlight washer jet

Fig. 1 - Expanding Clip, Removing:

• pierce pin on expanding clip
• remove clip

Fig. 2 - Front Spoiler/wheel House Liner, Securing:

1 = fender
2 = wheel house liner
3 = screw/washer
• 8 Nm (4.4 ft lb)
4 = Spoiler

Fig. 3 - Front Spoiler Top Mounting, Assembly:

1 = headlamp mounting
2 = bracket
• part of bumper trim
3 = screw/washer
• 6 Nm (4.4 ft lb)
• must be unscrewed prior to reinstalling Spoiler