Fluid - A/T: Testing and Inspection

ATF, checking/filling

Checking

Note: The transmission fluid level Only needs to be checked when diagnosing a suspected transmission problem.

Always check transmission fluid under the following conditions:
Selector lever at P
Engine idling






CAUTION: Vehicle must be on level surface during ATF check. Use only lint-free cloth when wiping dipstick.

Check ATF initially. when engine is cold
fluid level must be up to 20°C (68°F) mark

Bring ATF to operating temperature (60°C/140°F)
Drive approximately 10 km from a cold start to reach operating temperature
Measure operating temperature using VAG 1551

Check ATF dipstick again. Level must be between Max. and Min. marks
If too high, drain fluid to specifications. Probe Z417 113 WE and VAG 1358 can be used for this purpose
If too low, add fluid to specifications

CAUTION: Do NOT overfill transmission.

Filling

CAUTION: Only use ATF with the designation "DEXRON." Do NOT use lubricant additives. Use only lint-free cloth when wiping dipstick.

Remove transmission dipstick and insert funnel into filler tube
Add ATF
During initial filling, add 3 liters
Start engine
Select all lever positions with vehicle stationary
Check ATF level