Differential Lock Mechanism

COMPONENT NOTES AND INFORMATION
1 Switch
- Tighten to: 45 Nm (33 ft lb)
- For indicator lamp
2 Extension pin
3 Boot
- Removing, pry out, making sure sealing surface is not damaged
- Installing, press in as far as stop, secure with hose clip at small diameter on selector fork
4 Vacuum element with holder
- Disassembling, refer to items -9 through 12-
5 Bolts
- Tighten to: 25 Nm (18 ft lb)
6 Sliding sleeve
7 Selector fork
8 Clip
9 Pin
10 Clevis
11 Holder
- For vacuum element -12-
12 Vacuum element
13 Shoulder bolt
- Quantity: 2
- Tighten to: 35 Nm (26 ft lb)
- Guide for selector fork -7-
14 Shoulder bolt
- 35 Nm (26 ft lb)
- Stop for selector fork
15 Rear final drive
16 Vacuum hose
- Yellow
- At outer connection of vacuum element
17 Vacuum hose
- Color: Blue
- At inner connection of vacuum element





VACUUM LINE ROUTING DIAGRAM
A Control element
- Below rear seat
B Wiring harness
- To switch for differential lock mechanism
- To speedometer
C Harness connector
- At control element
D Vacuum element
- At rear final drive
E Vacuum reservoir
- At top left of luggage compartment at area below hinge for lid
- Before removing, take off luggage compartment trim
- Wagon: Near left rear wheel housing, accessible through hinged cover
F Check valve
- Below rear seat