Telephone System - Removing/Installing
HANDS-FREE MICROPHONE AND SPEAKER, REMOVING/INSTALLINGMicrophone
The handsfree microphone is located behind the left A-pillar interior trim piece (arrow).
^ remove left A-pillar trim 2
^ unplug wire connector from microphone 1
^ remove two microphone securing screws
^ remove microphone from A-pillar trim
^ install in reverse order of removal
On some 1991 models, the hands-free microphone (arrow) is installed on the left side of sunroof motor cover, directly next to the interior light assembly.
SPEAKER
The handsfree speaker is located in the upper right portion of the dashboard.
^ carefully pry up speaker cover at (arrow)
^ remove speaker and disconnect wiring connections 1 install in reverse order of removal
CRADLE AND ANTENNA, REMOVING/INSTALLING
Cradle
The cradle (arrow) is attached to the driver armrest with four screws.
^ lift phone from cradle
^ remove rubber screw caps from two rear screws
^ remove four screws and lift out cradle
^ install in reverse order of removal
Antenna
The antenna is mounted on top of the right rear quarter panel.
^ switch phone OFF
^ remove antenna cable from receiver
^ unscrew antenna mast 1 from base
^ remove spanner nut (arrow) and remove upper antenna base plate
^ slide antenna base down through hole and remove
^ install in reverse order of removal
TRANSCEIVER, REMOVING/INSTALLING
The telephone transceiver (arrow) is mounted in the right side of the trunk and is held in place by a lockable sliding track mount 1.
Removing
^ unlock (with key) lock housing 3 and swing open
^ slide transceiver rearward on track mount enough to remove wire connections
^ loosen retaining screws 2 on 25-pin connector and remove power cord from transceiver
^ unscrew antenna cable and remove
^ slide transceiver fully rearward and lift from track mount
Installing
^ place transceiver onto mount with electrical connections facing front of car
^ connect power cord (25-pin connector) and antenna cable to transceiver
^ slide transceiver forward on mount to stop
CAUTION
Grooves in transceiver housing must fully engage
^ track mount to ensure secure mounting.
^ close lock housing and lock (with key)
CAUTION
Each transceiver has its own electronic serial number (ESN). ALWAYS register a new transceiver with the Cellular Telephone Company before placing a call.