Inside Rear-View Mirror Mounting Plate, Installing

CAUTION!
Read and observe all cautions and warnings on adhesive compound labels.


CAUTION!
Part numbers are for reference only. Always check with your Parts Department for latest information.


Parts Required

Description Part Number
Activator D 000 701
Metal adhesive D 000 702


NOTE: Adhesive is completely hardened after several hours.


Mounting for inside rear view mirror



- Single ball joint: dimension -a- = 95 mm (3.74)
- Double ball joint: dimension -a- = 130 mm (5.12 in.)


- Clean bonding surfaces on inside of windshield and on retaining plate.
- Spray on activator and wipe dry.
- Spray cleaned bonding surface on windshield again with activator and allow to dry 1 to 2 minutes.
- Apply drop of metal adhesive to center of cleaned surface of retaining plate.
- Press retaining plate onto prepared bonding surface for 30 seconds.
- Push on rear-view mirror and secure with Allen screw.
- Wipe off excess activator.


NOTE: Residual adhesive must be sanded off bonding surface of retaining plates which have fallen off