Rear Window Lock Out Switch - Replacement
Group: 70Number: 92-04
Date: 10/15/92
Subject:
Rear Window Lock-out Switch
Model(s):
1993 m.y.
90
up to VIN 8C-PA-040 755
Check/inspect for condition(s) described in this Bulletin when performing the Initial Delivery Inspection. When necessary perform corrective action(s) as outlined prior to delivery to the customer.
Replace switch following this procedure:
CAUTION
Do not replace switch if vehicle shows yellow dot on rear of rear view mirror or VIN is above 8C-PA-040 755.
- remove screw mounting armrest lower part -2- to upper part. Pull out armrest lower part toward rear.
- remove screws for armrest upper part -1-.
- slightly lift armrest upper part at lower end and press toward rear (arrow B)
- press down armrest upper part at bend (arrow B) and pull out of door trim panel at upper end (arrow C).
If necessary pry out with plastic wedge after wrapping contact surface of plastic wedge with tape.
Rear window lockout switch,
removing/installing
- using a small screw driver, carefully pry switch console from driver's door trim.
- remove plug connector
- carefully pry out lockout switch by inserting a small screw driver in slots (arrow) and pushing toward center of switch.
- install in reverse order of removal noting the following
- press in switch from below until you hear it "click" into place
- reinstall switch in arm rest assembly