Power Steering High Pressure Hose - Replacing
Group: 48Number: 94-01
Date: January 31, 1994
Subject:
Power steering high pressure hose, replacing 90/90 Quattro from 1993 m.y.
Model(s):
Cabriolet from 1994 m.y.
Condition
This Technical Bulletin is issued to clarify the repair procedure required when replacing the power steering high pressure hose -arrow- on all 90 models (from m.y. 1993).
Use the following recommended procedure when replacing a power steering high pressure hose.
Service
- Remove driver's side lower instrument panel cover
- Remove clip and clevis pin from brake pedal rod
- Remove nuts securing brake booster
- Remove engine cover and air intake hose
- Move brake booster far enough to allow access to steering hose banjo bolt.
Note
^ The brake booster does not have to be removed completely.
^ Access to the steering gear is easier from the underside of the engine when removing/installing the banjo bolt and hose.
- Remove lower engine pan
- Remove steering hose banjo bolt at steering gear
- Disconnect hose at pump connection and remove
- Install in reverse order.
- After installation, run engine and top off hydraulic fluid.
Warranty Labor code
48 94 11 0
Diagnosis Repair Quality Check
- 120 10