Solenoid Valves Vacuum Supply, Connecting

SOLENOID VALVES VACUUM SUPPLY, CONNECTING




- Remove the vacuum line between the fuel pressure regulator -1- and intake manifold -2- and cut through vacuum line at point -1- to a length of 40 mm

- fit both pieces onto the Y connector and again attach to the fuel pressure regulator and intake manifold

- Route the vacuum supply line (for the solenoid valves) that was disconnected from the brake servo check valve and connect to the Y connector near the fuel pressure regulator




- Attach the vacuum supply lines for the solenoid valves -3- onto the third port of the Y connector

Note
Route the vacuum line so that it does not interfere with the throttle body

- Secure vacuum line into position using a tie-wrap

- Make a final comparison of this entire installation using the vacuum diagram. The installation must agree with the diagram.