Preselect Sunroof - Does Not Stop In Correct Position
Group: 60Number: 93-02
Date: March 31, 1993
SUBJECT:
Pre-select sunroof does not stop in correct position
MODEL(s):
100 from 1992 m.y.
CONDITION
Zero-position set incorrectly at time of motor installation.
SERVICE
Check/adjust zero-position as follows:
Pre-select sunroof
Hole in drive gear must be aligned with center of drive gear and drive pinion for zero-position.
Zero-position of drive pinion is 1800 from setting of drive pinion for non preselect sunroof. (arrow)
- if necessary, reset motor zero-position with 4 mm Allen key
Non pre-select sunroof
Hole in drive gear must be aligned with center of drive gear and drive pinion for zero-position.
Zero-position of drive pinion is 180° from setting of drive pinion for preselect sunroofs. (arrow)
In this position the microswitch is OFF.
- if necessary, reset motor zero-position with 4 mm Allen key.