Rear

Rear brake pads, replacing (100/A6 models)

Removing

- Remove wheels.
- Mark positions of brake pads that are to be used again.
- Install again in same place to ensure uniform braking.






- Remove brake caliper housing.

CAUTION: Do not loosen brake hose or lines.
Secure the brake caliper with a piece of wire in order to relieve the stress on the brake hose.

- Remove brake pads.

WARNING: Brake fluid is poisonous and must never be extracted by mouth through a hose. if brake fluid contacts eyes or skin, flush or wash adequately to prevent irritation. Get medical attention if necessary.

CAUTION: Extract part of the brake fluid from the brake fluid reservoir before pushing back the pistons.
Use the bleeder bottle or a plastic bottle, which is used only for brake fluid, for extracting the fluid.

Installing









- Press piston in by turning clockwise and pushing forcefully.
- Install brake pads.
- Install brake caliper housing and tighten. Tightening torque: 35 Nm (26 ft lb)

Note: Four self-locking bolts are included in the repair kit and they must all be installed.

CAUTION: Perform basic adjustment of rear wheel brake thoroughly each time brake pads are changed, refer to Testing and Inspection/Procedures.