Blower Motor: Locations

The illustration shows two different heater box component arrangements:

Components marked with * are used with automatic climate control only
Components marked with + are used with manual A/C only






1. Control flap for instrument panel air outlets
2. Screw
3. Locking clips
4. Lever for footwell/defroster control flap*
5. Turbulence flap retaining assembly
6. Fresh air blower series resistance with fuse -N24-+
6a. Mounting bracket for fresh air blower ambient temperature sensor -G109-*
7. Snap ring
8. Washer
9. Grommet
10. Left housing half
11. Retaining clips
12. Mounting tabsforfresh airbiower
13. Fresh air blower -V2-
14. Heater core
15. Temperature flap
16. Temperature flap






17. Seal
18. Screw
19. Footwell/defroster flap+
19a. Footwell/defroster flap*
20. Stop pins+
21. Adhesive tabs
22. Turbulence flap
23. Sealing cord
24. Right housing half
25. Intake duct
26. Bearing
27. Temperature flap lever
28. Retaining washers
29. Locking clip*
30. Center flap lever+
31. Flap lever*
32. Screw

*Automatic climate control only
+Manual A/C only