Taillight Assembly, Removing and Installing

NOTE: The switch for luggage compartment light is located in tailgate lock. Luggage compartment bulb: 12 volts, 5 watts.

Taillight Assembly, Removing And Installing:

1 - Nut, M5
2 - Bracket
3 - Rear fog light bulb holder
4 - Rear fog light bulb
- 12 volts, 21 watts
5 - Back-up light bulb holder
6 - Back-up light bulb
- 12 volts, 21 watts
7 - Rubber seal
8 - License plate light bulb holder
9 - License plate light bulb
- 12 volts, 4 watts
10 - License plate light lens
11 - Seal
12 - Screw
13 - Wire connector
14 - Gasket
15 - Back-up light, rear fog light lens
- When removing on right side, first remove trunk lock
16 - Taillight, brake light, turn signal light lens
17 - Seal
18 - Brake and taillight bulb
- 12 volts, 21/5 watts
19 - Turn signal bulb
- 12 volts, 21 watts
20 - Wire connector
21 - Taillight, brake light, turn signal light bulb holder

Taillight, brake light, turn signal light bulb holder, removing and installing





- Turn lock bolt -A- counterclockwise.
- Remove connector -B-.
- Remove bulb holder.
Install in reverse order of removal.

NOTE: When connecting towing lights, use terminals -C- for all electrical connections.

Taillight, brake light, turn signal light lens, removing and installing





- Remove bulb holder.
- Remove nuts (arrows).
- Remove lens.

Install in reverse order of removal.

Back-up light, rear fog light bulb holders, removing and installing





- Turn each bulb holder in direction of (arrow) and remove.

Install in reverse order of removal.

Back-up light, rear fog light lens, removing and installing





- Remove bulb holders.
- Remove nuts (arrows).
- Remove lens.

Install in reverse order of removal.