Vacuum Line to Brake Servo Unit, Connecting

VACUUM LINE TO BRAKE SERVO UNIT, CONNECTING

Note




Do not remove the nut from the brake master cylinder. The bracket is attached with an additional nut.

- Tightly screw bracket -30- to threaded bolt with flat nut -31-

- Attach vacuum line to brake servo -20- using clip -28- at bracket -30-

- Attach brake line to bracket -30- with clip -32-




- Cut out portion of engine cover as illustrated.




- If the vehicle has no engine cover, attach lines to the fuel Injectors (for each one) behind the rubber grommet using a tie-wrap at the vacuum line

Note
Install the rubber grommets facing down so that the end of the grommet is no longer visible.