Procedures

Removing Shift-Rod Bushing For 3rd And 4th Shift Lever Rod From Transmission Cover
- Use special tool VW 771 and inside puller -A- 18.5-23.5 mm (3/4-15116 in.) e.g. Kukko 21/3






Pulling Bushing (arrow) For 3rd And 4th Shift Lever Rod Out Of Transmission Housing
- Use special tool VW 771 and inside puller -A- 18.5-23.5 mm (3/4-15/16 in.), e.g. Kukko 21/3






Installation Position Of Oil Seal For Inner Shift Rod
- Dimension -a- = 1 mm (0.04 in.)






Removing and Installing Shift Fork Bracket






Removing and Installing Oil Retainer
Removing
- Rotate and pull out oil retainer (arrow).
Installing
- Push oil retainer into transmission cover until detent on oil retainer engages in hole in cover
- Retainer points upward in transmission cover