Input Shaft Adjusting

- Clamp input shaft into vise using vise clamps.
- Place special tool 3167 (-A-) on 3rd gear and mount transmission housing over input shaft on special tool.






- Place depth gauge on housing and measure to lower groove in shaft.
Example: dimension -a- = 28.5 mm (1.122 in.)






- Place depth gauge on transmission housing and measure to ball bearing seat.
Example: dimension -b- = 26.8 mm (1.055 in.)
- Determine required thickness for lower circlip (dimension a - dimension b).
Example: circlip thickness = 28.5 mm -26.8 mm = 1.70 mm






- Determine circlip thickness from table.






- Knock circlip and ball bearing onto input shaft with installation sleeve 30-100.
- Determine thickest circlip possible that can be installed in groove.






- Available circlips