Track 18 Thru 27

Manual Air Conditioning (Automatic Transmission) - Track 18-27:

COMPONENTS
F118 = A/C Refrigerant High Pressure Switch
G111 = A/C Compressor Speed Sensor
J153 = A/C Clutch Control Module
N25 = A/C Clutch
F76 = Engine Coolant Temperature (ECT) Electronic Thermoswitch
G3 = Engine Coolant Temperature (ECT) Gauge
J192 = MFI Engine Control Module (ECM)
J268 = Mini Check System Control Module
J201 = Protection Diode
J217 = Transmission Control Module (TCM)
K = Wire Distributor For Data Link Connector (DLC); Terminal K

CONNECTORS
T10 = Wire Connector, 10 Point, black, connector station in auxiliary
T1m = Wire Connector, single, red, behind instrument panel, left
T1n = Wire Connector, single, green, near compressor
T26 = Wire Connector, 26 Point, yellow, on instrument cluster
T2am = Wire Connector, double, green, near compressor
T2z = Wire Connector, double, white, in Plenum, Near Relay Panel (Data Link Connector)
T5g = Wire Connector, 5 Point, green connector station in auxiliary relay panel
T5h = Wire Connector, 5 Point, red, behind instrument panel, left

GROUND CONNECTIONS

NOTE: Ground connections are indicated on the diagram by a numeric code inside a circle.

119 = Ground connection, in headlight wiring harness
127 = Ground connection, in A/C compressor wiring harness
29 = Ground connection, near compressor

HARNESS SPLICES

NOTE: Harness splices are points inside a wiring harness where two or more wires are crimped and/or soldered together. Harness splices are indicated on the diagrams by an alphanumeric code inside a circle.

A45 = Wire connection (RPM signal), in instrument panel wiring harness