Rear Bumper: Service and Repair

Rear Bumper Assembly





1 - Molding, center
2 - Split rivet
remove to separate bumper from bumper cover
3 - Bumper cover
4 - Bumper
Removing
• remove nut -7-
• pry bumper cover ends off over wheel house liner
• pull bumper with cover out of guide toward rear
• do not allow bumper to touch body
Installing
• install in reverse order, ensuring bumper cover is fitted into guides and over wheel house liner
5 - 23 Nm (17 ft lb)
6 - Impact absorber
7 - 23 Nm (17 ft lb)
8 - Guide
bumper cover slides over guide
9 - Screw
1.0 Nm (9 in lb)
10 - Trim molding, left/right
11 - Cover cap
covers gap between moldings